How to Check Your RV Battery
02/09/12
Checking your RV battery involves performing these two tests on a regular basis.
Preparation
Steps:
1. Access the RV battery you wish to check.
2. Make sure you are checking the 12-volt DC camper battery and not something connected to the 120-volt AC power supply. Run checks on all batteries in your vehicle and record the results.
3. Remove 5th wheel battery caps.
Tips:
The most common causes of premature battery failure are overcharging, sustained undercharging, sulfation and poor maintenance.
Warnings:
Electrolyte (battery acid) is corrosive to metal, skin, cloth, and so on. If spilled on skin or squirted into eyes, flush with baking soda and water to neutralize the acid and get immediate medical attention.
Batteries can give off explosive gases.
The Specific Gravity Test
Steps:
1. Perform a specific gravity battery test by inserting the syringe from the temperature-adjusted hydrometer and extracting the electrolyte (battery acid).
2. Read the gravity level. Record the result.
3. Return the electrolyte to the battery.
4. Repeat this procedure for each battery cell.
Tips:
Never perform a specific gravity test immediately after adding distilled water.
If the specific gravity test on any two cells in one battery has more than a .50 differential, the RV battery is bad and should be replaced.
With the specific gravity value test, the specific gravity level will read 1.265 if charged at 100 percent, 1.225 if charged at 75 percent, 1.190 if charged at 50 percent, 1.155 if charged at 25 percent and 1.120 if discharged.
The Open-Circuit Voltage Test
Steps:
1. Perform an open-circuit voltage test only if the battery has not been charged within the past 24 hours.
2. Remove negative battery cable.
3. Read the voltage across the negative and positive posts with a voltmeter. Record the result.
4. Reconnect the battery cable.
5. Close the hood or compartment storing the RV battery.
Tips:
Running the engine or plugging it into a 110-volt power source will charge the RV battery.
With the open-circuit voltage test, the voltage will read 12.6 or higher if the battery is charged 100 percent, 12.4 at 75 percent, 12.2 at 60 percent, 12.0 at 50 percent, 11.7 at 30 percent and 10.5 at zero.








